Chapter 3. Creating User Accounts
Kaye Validator AVS User’s Manual 47
3. Select the absolute pressure units for saturated steam calculations from the Pressure
Units list box. If you selected “Other”, enter the value of 1 Atmosphere in the absolute
pressure units you are using.
4. Press the 60 Hertz or 50 Hertz radio button to set the line frequency. Choose the
setting that matches your environment.
IMPORTANT: The aye Validator AVS filters noise induced by the AC Power in order
to achieve its high accuracy performance. If the line frequency is not set correctly, the
filter is not working correctly resulting in a higher signal noise level.
5. Press Yes or No to indicate if you want to enable a user to change lethality
calculations parameters.
6. Enter the lower limit for IRTD stability (From 250 to 400°C or 482 to 750°F). The
IRTD stability is fixed to 0.012°C but for high temperatures which threshold limit is
set with this value, or temperatures below 0°C, the IRTD stability value becomes
editable in the setup.
7. If necessary, you can enter an alternate machine identification number. The machine
ID appears in the audit trail for identification of the console.
8. Logo: Import of a custom logo that can be any kind bitmap.
9. Display rate: Defines the rate the live data is updated in the monitoring view. It is not
affecting the data storage rate as defined in the setup.
10. The path and folder that holds the Data Directory is displayed.
To Next Page
Loading...
