Chapter 8. Viewing Live Data
Kaye Validator AVS User’s Manual 87
8.1 Select Validator AVS (cont.)
Figure 51: Select Validator AVS
Screen
Note: In case a Validator AVS is not in the same IP segment the discover function will not find it.
Nonetheless if the TCPIP address of the Validator is known and the connection not blocked the
connection can be established by entering the IP address and adding the Validator AVS to the
available devices manually.
Press the tile for the Validator AVS you need to use, and then press Connect to establish the
connection between the Console and the Validator AVS.
For configuring the Wi-Fi connection select a Validator and press “Configure WiFi”. The
connection needs to be established by docking (recommended) or Ethernet. Enter all the
necessary information and after pressing “ok” the information is transferred to the Validator.
The Validator will now use this information to connect to the specified Wi-Fi network and
will be available with the “”Discover”-Button.
To Next Page
Loading...
