6. Engine Removal;In
spection & Installation
6-35
2．Ex
haust CAM standard height： 32.763 mm
min-height： 32.643 mm
●If less than rating, please replace the camshaft.
3 CAM shaft axis shaft neck inspection
Shaft neck standard outside diameter：
37.946-37.960 mm
Such as measuring results less than rating,
then replace the camshaft
4.12．Cylinder head check
1．The cylinder head flatness check
As shown in figure six direction cylinder
head top surface of measuring flatness
The cylinder head flatness standards ：↓0.03 mm
● If not within this, then replace the cylinder head.
The cylinder head valve seat inspection and m
aintenance
6
To Next Page