Keithley 2701

Scan configuration .................................................................... 7-11
Scan reset .......................................................................... 7-13
Simple scan ....................................................................... 7-13
Advanced scan .................................................................. 7-14
Setting delay ...................................................................... 7-18
Monitor channel ................................................................ 7-18
Auto channel configuration ............................................... 7-20
Saving setup ...................................................................... 7-21
Auto scan .......................................................................... 7-21
Scan operation .......................................................................... 7-21
Basic scan .......................................................................... 7-22
Manual/external trigger scan ............................................. 7-23
Monitor scan (analog trigger) ........................................... 7-24
Remote programming — scanning .......................................... 7-26
Trigger model .................................................................... 7-26
Channel setup .................................................................... 7-27
Buffer ................................................................................ 7-27
Scanning commands ......................................................... 7-27
Scanning programming example ...................................... 7-32
Scanning examples ................................................................... 7-32
External trigger scan ......................................................... 7-32
Monitor scan ..................................................................... 7-35
8 Triggering
Trigger model ............................................................................. 8-2
Idle ...................................................................................... 8-2
Control source and event detection ..................................... 8-3
Delay (auto or manual) ....................................................... 8-3
Device action ....................................................................... 8-5
Output trigger ...................................................................... 8-5
Reading hold (autosettle) ........................................................... 8-6
Hold example ...................................................................... 8-6
External triggering ..................................................................... 8-7
Digital I/O ........................................................................... 8-8
External trigger ................................................................... 8-8
Voltmeter complete ............................................................. 8-9
External triggering example .............................................. 8-10
External triggering with BNC connections ....................... 8-13
Remote programming – triggering ........................................... 8-14
Trigger model (remote operation) ..................................... 8-14
Trigger model operation .................................................... 8-16
Triggering commands ....................................................... 8-17
Programming example ...................................................... 8-18