Name: Keithley 2701
Brand: Keithley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Model 2701 User’s Manual Rel, Math, Ratio, Channel Average, dB 5-11

Basic operation

NOTE If using switching module inputs, make sure the front panel INPUTS switch is set

to the REAR position (in). If using the front panel inputs, the switch must be in

the FRONT position (out).

1. Conﬁgure and enable the mX+b, percent, or reciprocal (1/X) math function as

previously explained.

2. Select the desired measurement function.

3. Apply the signal to be measured to a switching channel input or to the front panel

inputs.

NOTE For the Model 7700 switching module, channels 21 and 22 are available for

DCI and ACI. Channels 1 through 20 are available for all other functions.

4. If using a switching module (REAR inputs selected), use the

 or  key to select

(close) the input channel. If using the front panel inputs (FRONT inputs selected),

it does not matter if a switching channel is closed. The result of the math

calculation will be displayed.

Scanning

When a simple scan is conﬁgured, the present math calculation will apply to all channels

in the scan. When an advanced scan is conﬁgured, each channel can have its own unique

math setup. Details to conﬁgure and run a scan are provided in Section 7.

For remote programming, the <clist> parameter is used to conﬁgure channels for a scan.

Other manuals for Keithley 2701

Questions and Answers:

Need help?

Do you have a question about the Keithley 2701 and is the answer not in the manual?

General