Keithley 2701 User Manual

B-6 Model 7700 Connection Guide Model 2701 User’s Manual
Wiring procedure
Use the following procedure to wire the Model 7700 module. Make all connections using
correct wire size (up to 20 AWG). Also, make sure to add supplementary insulation around
the harness for voltages above 42V peak (Figure B-4).
WARNING All wiring and supplementary insulation must be rated for the
maximum voltage in the system. For example, if 1000V is applied to
the front terminals of the DMM, the plug-in module wiring must be
rated for 1000V.
1. Make sure all power is discharged from the Model 7700 module.
2. Access the screw terminals (Figure B-2).
3. Using a small flat-blade screwdriver, loosen terminal screws and install wires as
desired. (Figure B-4 shows connections to channels 1 and 2.)
4. Route wire along wire-path and secure with cable tie as shown.
5. Fill in a copy of the connection log (Table B-1) and affix it to the module cover.
6. Close and lock cover.

Keithley 2701 Specifications

General

Max Voltage	300 V
Max Current	3 A
Frequency Range	3 Hz to 500 kHz
Frequency Accuracy	0.01%
Weight	3.6 kg
Measurement Functions	Frequency, Temperature
Interface	IEEE-488 (GPIB), RS-232
DC Voltage Range	300 V
DC Current Range	3 A
AC Voltage Range	300V
AC Current Range	1 μA to 3 A
Resistance Accuracy	0.01%
Channels	10
Dimensions	213mm x 88mm x 370mm