Keithley 2701 User Manual

Model 2701 User’s Manual Getting Started 1-29
Quick start exercises (QS3)
This section topic summarizes the following basic instrument operations and provides
simple exercises to perform them:
• Basic DMM measurements — front panel inputs.
• Closing and opening channels — system channel operation.
• Simple scanning.
• Trigger and return readings — remote programming.
NOTE For remote operations, you can use the internal web page of the Model 2701 to
send commands, queries, and take readings. See “Internal web page” in
Section 10 for details.
Also, supplied TestPoint Runtime start-up software can be used to control the
Model 2701. See Section 4 in the Model 2701 Instrument Networking Instruc-
tion Manual for details
WARNING For the exercises, it is not necessary to connect an input signal or DUT
to the instrument (front panel inputs or switching module inputs).
However, if you decide to use an input signal, it is recommended that
you keep it at a nonhazardous level (<42V) while learning to use the
instrument.
NOTE When using the front panel input terminals, the INPUT switch must be in the
“F” (out) position. The INPUT switch is located on the right side of the front
panel near the input terminals. When using a switching module, the switch must
be in the “R” (in) position.

Keithley 2701 Specifications

General

Max Voltage	300 V
Max Current	3 A
Frequency Range	3 Hz to 500 kHz
Frequency Accuracy	0.01%
Weight	3.6 kg
Measurement Functions	Frequency, Temperature
Interface	IEEE-488 (GPIB), RS-232
DC Voltage Range	300 V
DC Current Range	3 A
AC Voltage Range	300V
AC Current Range	1 μA to 3 A
Resistance Accuracy	0.01%
Channels	10
Dimensions	213mm x 88mm x 370mm