Name: Keithley 2701
Brand: Keithley
Rating: 4 (1 reviews)

To Next Page

To Previous Page

7-2 Scanning Model 2701 User’s Manual

Scanning fundamentals

The Model 2701 can scan the channels of up to two installed Keithley switching modules.

Each scan channel can have its own unique setup. Aspects of operation that can be

uniquely set for each channel include function, range, rate, AC bandwidth, rel, ﬁlter,

digits, math, Ω offset compensation, TEMP transducers, limits, channel average, channel

ratio, and volts dB.

NOTE Readings for scanned channels are automatically stored in the buffer. With

buffer auto clear enabled (which is the default), the buffer clears when the scan

is started. When disabled, scan readings are appended to the buffer. The

TRACe:CLEar:AUTO <b> command is used to enable/disable buffer auto clear

(Section 6).

A pseudocard can be installed in an empty slot. With the 7700 pseudocard

installed, the instrument will operate as if a Model 7700 switching module is

installed in the slot. This allows the user to conﬁgure a scan and exercise its

operation before the switching module is installed in the Model 2701. Use the

following commands to install 7700 pseudocards in empty slots:

SYSTem:PCARd1 C7700 ‘Install’ 7700 pseudocard in slot 1.

SYSTem:PCARd2 C7700 ‘Install’ 7700 pseudocard in slot 2.

Pseudocards for other switching modules can instead be installed. Details on

installing other pseudocards are provided in Section 2.

There are SCPI commands to query the capabilities of the installed switching modules.

For example, the following queries are provided to determine which channels of a

Model 7700 in slot 1 are available for volts/2-wire ohms and which channels are available

for amps. Note that the returned values for the Model 7700 switching module are shown in

parenthesis.

SYSTem:CARD1:VCHannel[:STARt]? ' Query first volt/Ω2 channel(7700; "1").

SYSTem:CARD1:VCHannel:END? ' Query last volt/Ω2 channel (7700; "20").

SYSTem:CARD1:ACHannel[:STARt]? ' Query first amps channel (7700; "21").

SYSTem:CARD1:ACHannel:END? ' Query last amps channel (7700; "22").

All the commands to query switching module capabilities are covered in Table 15-7.

Keithley 2701 Specifications

General

Keithley 2701 User Manual

Other manuals for Keithley 2701