Model 2701 User’s Manual Getting Started 1-15
1 DIGITAL I/O (EXT. TRIG.)
Male DB-9 connector for digital input (trigger link in) and digital outputs.
2 TRIGGER LINK
Eight-pin micro-DIN connector for sending and receiving trigger pulses among connected instruments. Use a
trigger link cable or adapter, such as Models 8501-1, 8501-2, 8502, and 8503.
3 ETHERNET
RJ45 female connector for Ethernet operation. Use an RJ45 male/male cable for connection. Two status LEDs
are located at the top of the connector. These LEDs indicate the status of the Ethernet (see Section 10, “Ethernet
connections”).
4 RS-232
Female DB-9 connector for RS-232 operation. Use a straight-through (not null modem) DB-9 shielded cable.
5 Power module
Contains the AC line receptacle, power line fuse, and line voltage setting. The instrument can be configured
for line voltages of 100V/120V/220V/240VAC at line frequencies of 50 or 60Hz.
6 Slot 1 and Slot 2
Two slots to accommodate Keithley Model 77xx series switching modules. The Model 2701 is shipped from
the factory with slot covers installed. Please note additional slot covers can be requested from
Keithley Instruments.
WARNING Slot covers must be installed on unused slots to prevent personal con-
tact with high voltage circuits.
To Next Page
Loading...
Need help?
General
