Keyscan CA150 - Page 108

Keyscan Inc. A Member of the Kaba Group – CA150 Rev. B Installation Guide (07.15)
108
Table 17 – CA150B Quick Reference
Function
Location
Instructions/Notes
Additional
Reference
Power
PoE - Ethernet terminal
Maximum current load for all
devices = 680 mA
See page 58.
12 VDC – Power In (+) & (-)
terminals
See page 58
Reader 1 and 2
Data 0, Data 1
Wiegand signal
DIP Switches & Jumpers
J1 – Clear Memory
Resets board to factory defaults
See page 48.
S1.1 to S1.12 – System
Configuration
For communication and system
settings
See page 36.
S2.1 to S2.6 – Reader
Configuration
Sets system to specific reader
format/type
See page 40.
S2.7 to S2.8 – Supervision
Mode
Sets the input supervision type
See page 47.
S2.9 to S2.10 – System
Software Mode
Sets the board for the Keyscan
system software application
See page 39
J6 – System Reset
Resets the control board to affect
communication or jumper
changes
J8 to J9 – Door Output Relay
Powered/Unpowered
Sets Door relay with power from
control board or as a dry contact
See page 50.
J10 to J11 – Aux Output
Relay Powered/Unpowered
Sets Aux relay with power from
control board or as a dry contact
See page 50.
Wiegand LED Card Bits
10s, 1s
10s counts first binary digit
1s counts the second binary digit
See page 46.
Communication
RS-232
For direct RS-232 serial
communication, connect to RS-
232 (TB5) terminal block
S1.10 & S1.11 – switches OFF
See page 51.
Ethernet - Operation Mode
(Network TCP/IP)
For network communication,
connect network cable to on-
board Ethernet terminal
S1.10 – switch ON / S1.11 –
switch OFF
See page 51.
Ethernet - Program Mode
(Network TCP/IP)
Ethernet program mode uses RS-
232 via TB5 at 9600 BPS.
S1.10 – Switch ON / S1.11 –
switch ON
RS-485
For future use
Control Board Test
Voltages
See Table 9 on page
62.
Communication Test
Voltages
See Table 10 on page
63.