Service 2
Keysight 53210A/53220A/53230A Assembly Level Service Guide 107
To pack in the original packaging materials
Whenever possible, repack the instrument in its original packaging for shipment.
In any correspondence, refer to the instrument by the model number and
complete serial number.
– Disconnect the power cord, probes, cables, or other accessories attached to
the instrument.
– Make sure the folded corrugated spacer (which normally contains the
manuals) is in the box to ensure proper fitting.
– Make sure one of the polystyrene blocks is in its proper position in the shipping
box.
– Place the instrument, front panel end first, on the polystyrene block.
– Place the other polystyrene block on top of the rear end of the instrument to
secure it. Seal the shipping container securely.
– Do not return the manuals with the instrument. Return an accessory only when
it is a part of the failure symptoms.
To pack in commercially available materials
If the factory packaging materials are not available, you can use commercially
available materials for shipping.
– Wrap the instrument in heavy paper or plastic.
– Place the instrument in a strong shipping container.
– A double-wall carton made of 350-lb. test material is adequate.
– Protect the control panel with cardboard.
– Add a layer of shock-absorbing material.
– The shock-absorbing material should be 70 to 100 mm (3 to 4 inches) thick
around all sides of the instrument to prevent movement inside the
container.
– Seal the shipping container securely.
– Mark the shipping container FRAGILE.
To Next Page
Loading...
Need help?
General
