4-14 Keysight B2900 User’s Guide, Edition 5
Front Panel Reference
Display and Assist Keys
List sweep setup When the field pointer is in the EDIT (green) status on the LIST sweep
Start/Stop/Points field, the following assist keys are available for setting the list
sweep source.
Edit Opens the List Sweep dialog box used to set the list sweep
source.
Load Opens the Load List Sweep Data dialog box used to load a list
sweep data from a USB memory connected to the front panel
USB-A connector.
• List Sweep dialog box
This dialog box provides the following fields for setting the list sweep source.
After the list is completed, press OK to apply the data and close the dialog box.
(data graph) Displays the shape of the list sweep output
(data list) Lists the data index in the left cell and the output value in
the right cell.
When the pointer is in the MOVE status, the pointer can be
moved in the crosswise direction. And pressing the knob
changes the status to EDIT.
When the right cell is in the EDIT status, the output value
can be entered to the cell.
When the left cell is in the EDIT status, the following assist
keys are available for creating and scrolling the list. Then
the pointer can be moved in the lengthwise direction. And
pressing the knob changes the status to MOVE.
Append Adds a line below. The same output value
is entered into the right cell.
Insert Adds a line above. The same output value
is entered into the right cell.
Delete Deletes the line.
Scroll -100 Moves the pointer to the maximum 100
points above.
Scroll +100 Moves the pointer to the maximum 100
points below.
Type Data type V (voltage) or I (current)
CH Channel number 1 or 2, only on 2-channel models
To Next Page
Loading...
Need help?
General
