Keysight Truevolt Series User Manual

Default Gateway
A gateway is a network device that connects networks. The default gateway setting is the IP address of
such a device.
l You need not set a gateway address if using DHCP.
l Contact your LAN administrator for details.
l This setting is non-volatile; it will not be changed by power cycling or *RST or SYSTem:PRESet.
l
Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
Then set the first softkey to Manual and press More and Gateway. Then set the appropriate gateway
address using the arrow keys.
l
SCPI: SYSTem:COMMunicate:LAN:GATeway "<address>"
l
If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
SYSTem:COMMunicate:LAN:UPDate (remote interface) for the change to take effect.
Hostname
A hostname is the host portion of the domain name, which is translated into an IP address.
l The instrument receives a unique hostname at the factory, but you may change it. The hostname must
be unique on the LAN.
l The name must start with letter; other characters can be an upper or lower case letters, numeric digits,
or dashes ("-").
l This setting is non-volatile; it will not be changed by power cycling or *RST or SYSTem:PRESet.
l
Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
Then press Host Name and enter the hostname with the front panel arrow keys.
l
SCPI: SYSTem:COMMunicate:LAN:HOSTname "<name>"
l
If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
SYSTem:COMMunicate:LAN:UPDate (remote interface) for the change to take effect.
Domain Name
A domain name is a registered Internet name that gets translated into an IP address. You cannot set it from
the front panel or SCPI.
Introduction to the Instrument
30
Keysight Truevolt Series Operating and Service Guide

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English