KIP 2080 - Re-Edit

A75UM3EJ (Ver. E.2)
3-131
A. Re-edit
[Function]
Even if you have printed out the Set Copy Job pushing the Start Key, it is still stored in the memory.
It is possible to call back the Set Copy Job by the Re-edit Function to make it possible to print it out
again or to edit it by such functions as Delete, Insert and Replace.
However, note that it becomes impossible to call back the Set Copy Job in the following cases
since it is deleted from the memory.
1. In case you have scanned the next original before calling back the Set Copy Job.
2. In case you have done “All Cancel”. (As for “All Cancel”, refer to the page 3-141.)
3. In case the data in the memory have been cleared by way of “Auto Clear” or “Clear”.
(As for these functions, refer to “Memory” on the page 3-161.)
[How to call back the Set Copy Job]
1) You have already printed out the stored Set Copy Job pushing the Start Key and the Set Copy
Mode has been cancelled.
2) Press “Re-Edit” in the Page Edit Screen to call back the Set Copy Job.
The Set Copy Mode is validated and it becomes possible to edit the Set Copy Job since setting
items “Delete”, “Insert” and “Replace” in the Page Edit Screen are validated.
The LED lamp of the Set Copy Key lights up and the Set Copy Mode is validated.
SET COPY
AUTO ZOOM AUTO PAPER
POWER
SAVE
INTERRUPT
RESET
RE COPY
ROTATE
SAMPLE
CONCURRENT
PRINT
23%
001
Page Edit
Delete
Insert Replace
Re Edit All Cancel Back
23%
001
Page Edit
P.1/10
Delete
Insert Replace
Re Edit All Cancel Back