Need help?Do you have a question about the Klemsan Klea 320P-D and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | Klea 320P-D |
| Brand | Klemsan |
| Display Type | LCD |
| Battery Type | 9V Battery |
| Operating Temperature | 0°C to 40°C |
Explains warning symbols and general safety precautions for device installation and operation.
Details how to check the package contents and ensure the product is received in good condition.
Provides a description of the KLEA Energy Analyzer, its features, and capabilities.
Describes the KleaCom software for remote access, monitoring, and configuration of the KLEA device.
Explains the layout and functions of the KLEA device's front panel display and controls.
Illustrates the four-quadrant energy flow representation used by the KLEA meter.
Guidance on preparing the device and ensuring safety before installation.
Instructions on how to physically mount the KLEA device into a panel.
Detailed wiring diagrams for different connection types (3P4W, 3P3W, Aron).
Diagram illustrating the connection for digital output signals.
Provides the physical dimensions of the KLEA device in millimeters.
Initial configuration settings upon first power-up, including language, date, time, and ratios.
Configuration for device language, date, and time settings.
Setting of Current Transformer Ratio (CTR) and Voltage Transformer Ratio (VTR).
Selection of the electrical network connection type (3-phase 4-wire, 3-wire, Aron).
Details the startup screen display and access to the main settings menu.
Configuration options for network parameters and device-specific settings like language.
Setting initial energy values and tariff start times for meter synchronization.
Configuration for digital inputs and outputs, including modes, delays, and assignments.
Setup for analog output channels, including input mode, output connection, and scaling.
Configuring communication parameters (Baud Rate, Slave ID) and alarm thresholds.
Viewing instantaneous measurements and demand values for power, current, and voltage.
Analyzing harmonics in table/graph format and viewing energy meter values.
Monitoring alarm statuses for various parameters like voltage, current, and harmonics.
Displaying minimum, maximum, and average values for measured parameters.
Guidelines for RS485 wiring and connecting the KLEA device to a PC.
Details the message structure and data types used in the Modbus RTU protocol.
Lists the Modbus functions implemented by the KLEA device for communication.
Table of read-only registers for measured and calculated data, including addresses and types.
Register map for KLEA setting parameters, including network, device, and energy settings.
Information on accessing hourly, daily, and monthly archive data using Modbus file records.
Procedure for erasing/zeroizing stored data using Modbus commands.
Lists default values for network and device configuration parameters.
Default values for energy-related settings and digital/analog output configurations.
Default settings for alarm thresholds, hysteresis, and communication parameters.
Electrical supply requirements and specifications for voltage and current measurement inputs.
Details the accuracy classes and measuring ranges for various electrical parameters.
Technical details for relay outputs, digital I/O, and analog output options.
Specifications for CTR, VTR, demand period, operating temperature, and humidity.
Physical dimensions, protection class, and power consumption of the KLEA device.
To Next Page