350| Customizing, recording and editing the Songs
4 If you want to use the advanced parameters, allowing you to select a velocity
curve and create fade-ins or fade-outs, select the Advanced checkbox.
When this parameter is selected, the Intensity, Curve, Start Velocity Value
and End Velocity Value parameters become accessible.
â–ª Use the Intensity parameter to specify the degree to which the velocity data
will be adjusted toward the curve you specify with Curve.
Intensity Meaning
0 … 100% Intensity value. With a setting of 0%, the velocity will not change.
With a setting of 100%, the velocity will be changed the most.
â–ª Use the Curve parameter to select one of the six curves, and specify how the
velocity will change over time.
Start
Value
Curve 1
Velocity
Start Value = 0%, End Value = 100%
127
1
End
Value
Start
Value
Curve 2
Velocity
127
1
End
Value
Start
Value
Curve 3
Velocity
127
1
End
Value
Start
Value
Curve 4
Velocity
127
1
End
Value
Start
Value
Curve 5
Velocity
127
1
End
Value
Start
Value
Curve 6
Velocity
RANDOM
127
1
End
Value
â–ª Use the Start Vel. Value and End Vel. Value to change the velocity value at
the starting and ending of the selected curve.
Intensity Meaning
0 … 100% Velocity change in percentage
5 Use the Start Tick and End Tick parameters to set the beginning and ending
of the phrase to be edited.
If a phrase is four measures long, and you want to select it all, the Start will
be positioned at 1.01.000, and the End at 5.01.000.
6 Use the Bottom Note and Top Note parameters to set key range to change.
If you select the same note as the Bottom and Top parameters, you can se-
lect a single percussive instrument in a Drum Kit. Selecting a range can also
be used to only edit RX Noises (from C7) or ordinary notes (under C7).
To Next Page
Loading...
Need help?
General
