500| Audio In/Out, Voice and Guitar Processor
Accessing the Master EQ
1 Go to the Global > Limiter/Master EQ > Master EQ page.
Turning the Master EQ on/off
▪ Use the On/Off button to turn the EQ on/off.
Programming the EQ
▪ Look at the results of any edit in the diagram. The diagram shows the EQ
curve. Its shape changes depending on the various parameter values.
▪ Use the Input Trim parameter to adjust the level of the signal entering the
EQ. Excessive amount of signal may cause distortion when boosting the EQ
bands.
▪ Use the Gain parameter to change the emphasis or attenuation of the cor-
responding band. Use it to make the frequencies stronger or weaker.
Band Value
All Bands -18...0...+18dB
▪ Use the Freq parameter to change the center frequency of the correspond-
ing band. Center it on the problematic frequency, or the harmonics you want
to emphasize or attenuate.
Band Type of EQ curve Value
Low Shelving 20Hz...1kHz
Mid-Low Peaking 50Hz...10kHz
Mid-High Peaking 300Hz...10kHz
High Shelving 500Hz...20kHz
To Next Page
Loading...
