536| Audio In/Out, Voice and Guitar Processor
Programming the individual harmony voices
The center area of the page contains parameters to program the individual
voices. It is different, depending on the selected Harmony Type.
Harmony Type Individual Voice Box
Chord
Scale
Shift
Notes
▪ Use the V1…V3 buttons to choose the harmony voice to program.
Choosing the Voicing for Chord-type harmonies
▪ Use the Voicing pop-up menu to specify the relation of the harmony note to
the input note with respect to the current chord. In Chord mode presets, the
harmony voices are always notes in the chord. A setting of Up1 will result in
the harmony voice being the next note above the input voice in the chord.
For instance, if the chord was C Major and the input note was an E, an Up1
setting would produce a G harmony voice, just above the input E.
Choosing the Scale for Scale-type harmonies
▪ Use the Scale pop-up menu to specify the interval of the harmony note with
respect to the input note in the scale. The range of values goes from -2VE,
which is 2 octaves below the input note, to +2VE which is two octaves above
the input note. For example, a setting of +3 will result in a harmony voice a
third above the input voice.
To Next Page
Loading...
