Korg PA1000

Effect parameters |647
c Preset Type V1, C1, V2, C2,
V3, C3
Selects the effect type when Mode=Preset
V1/V2/V3 are variations of vibrato, and C1/C2/
C3 are variations of chorus
Src Off…Tempo Selects the modulation source that will change
the effect type
Amt –5…+5 Sets the modulation amount for changing the
effect type
d Custom Mix Vibrato,
1:99…99:1,
Chorus
Sets the mix level of the direct sound when
Mode=Preset
Src Off…Tempo Selects the modulation source that will control
the mix level of the direct sound
Amt –100…+100 Sets the modulation amount for controlling the
mix level of the direct sound
e Custom Depth 0…100 Sets the vibrato depth
Src Off…Tempo Selects the modulation source that will control
vibrato depth
Amt –100…+100 Sets the modulation amount for controlling the
vibrato depth
f Custom Speed
[Hz]
0.02…20.00 Sets the vibrato speed
Src Off…Tempo Selects the modulation source for controlling
the vibrato speed
Amt –20.00…
+20.00
Sets the modulation amount for controlling the
vibrato speed
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
b: Control Mode
c: Preset Type
d: Custom Mix
e: Custom Depth
f: Custom Speed [Hz]
If Control Mode=Preset, you can use c: Preset Type to select the effect.
In this case, the Custom Mix/Depth/Speed settings are ignored. If Control
Mode=Custom, the Custom Mix/Depth/Speed settings are valid, and the c:
Preset Type setting is ignored.