Effect parameters |649
e Rotor
Acceleration
0…100 Determines how quickly the rotor rotation
speed in the low range is switched
Rotor Ratio Stop,
0.50…2.00
Adjusts the (low-frequency) rotor speed.
Standard value is 1.00. Selecting “Stop” will
stop the rotation
f Horn/Rotor
Balance
Rotor, 1…99,
Horn
Sets the level balance between the high-fre-
quency horn and low-frequency rotor
g Mic Distance 0…100 Sets the distance between the microphone and
rotary speaker
Mic Spread 0…100 Sets the angle of left and right microphones
h Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Mode
This parameter sets how the modulation source switches between rotation
and stop.
When Mode = Toggle, the speaker rotates or stops alternately each time you
press the pedal or move the joystick. Via MIDI, rotation will switch between
start and stop each time the modulation amount exceeds 64.
When Mode = Moment, the speaker rotates by default, and stops only when
you press the pedal or move the joystick. Via MIDI, modulation values above
64 make the speaker rotate, and values below 64 make it stop.
b: Speed Switch
This parameter controls how the rotation speed (slow and fast) is switched
via the modulation source.
When Mode = Toggle, the speed will switch between slow and fast each time
you press the pedal or move the joystick. Via MIDI, the speed will switch each
time the modulation amount exceeds 64.
When Mode = Moment, the speed is usually slow. It becomes fast only when
you press the pedal or move the joystick. Via MIDI, modulation values above
64 set the speed to Fast, and values below 64 set it to Slow.
To Next Page
Loading...
Need help?
General
