Effect parameters |739
b Pitch Shift
[1/2tone]
–24…+24 Sets the pitch shift amount by steps of a semi-
tone
Src Off…Tempo Selects the modulation source of pitch shift
amount
Amt –24…+24 Sets the modulation amount of pitch shift
amount
c Fine [cents] –100…+100 Sets the pitch shift amount by steps of a cent
Amt –100…+100 Sets the modulation amount of pitch shift
amount
d Delay Time
[msec]
0…2000 Sets the delay time
e Feedback
Position
Pre, Post Switches the feedback connection
f Feedback –100…+100 Sets the feedback amount
High Damp [%] 0…100 Sets the damping amount in the high range
g Input Level Dmod
[%]
–100…+100 Sets the modulation amount of the input level
Src Off…Tempo Selects the modulation source for the input
level
h Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Mode
This parameter switches the pitch shifter operating mode. With Slow, tonal
quality will not be changed too much. With Fast, the effect becomes a Pitch
Shifter that has a quick response, but may change the tone. Medium is in-
between these two. If you do not need to set too much pitch shift amount, set
this parameter to Slow. If you wish to change the pitch significantly, use Fast.
To Next Page
Loading...
