Korg PA1000

74 0 | Effects for the Sounds, Voice, Guitar
b: Pitch Shift [1/2tone]
b: Src
b: Amt
c: Fine [cents]
c: Amt
The amount of pitch shift will use the value of the Pitch Shift plus the Fine
value. The amount of modulation will use the b: Amt value plus the c: Amt.
The same Modulation Source is used for both Pitch Shift and Fine.
e: Feedback Position
f: Feedback
When Feedback Position is set to Pre, the pitch shifter output is again input
to the pitch shifter. Therefore, if you specify a higher value for the Feedback
parameter, the pitch will be raised (or lowered) more and more each time
feedback is repeated.
If Feedback Position is set to Post, the feedback signal will not pass through
the pitch shifter again. Even if you specify a higher value for the Feedback
parameter, the pitch-shifted sound will be repeated at the same pitch.
Pitch Shifter BPM
This pitch shifter enables you to set the delay time to match the song tempo.
BPM
BPM
Base Note x Times
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Pitch Shifter
Feedback Position
Pre
Post
Tempo
a Mode Slow,
Medium, Fast
Switches Pitch Shifter mode