Korg PA1000

Effect parameters |74 1
b Pitch Shift [1/2tone] –24…+24 Sets the pitch shift amount in steps of a
semitone
Src Off…Tempo Selects the modulation source of pitch
shift amount
Amt –24…+24 Sets the modulation amount of pitch shift
amount
c Fine [cents] –100…+100 Sets the pitch shift amount in steps of one
cent
Amt –100…+100 Sets the modulation amount of pitch shift
amount
d BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individual
effect
Time Over? ---, OVER! Displays an error message when the delay
time exceeds the upper limit
e Delay Base Note
…
Selects the type of notes to specify the de-
lay time
Times x1…x32 Sets the number of notes to specify the
delay time
f Feedback Position Pre, Post Switches the feedback
connection
g Feedback –100…+100 Sets the feedback amount
High Damp [%] 0…100 Sets the damping amount in the high range
h Input Level Dmod [%] –100…+100 Sets the modulation amount of the input
level
Src Off…Tempo Selects the modulation source for the in-
put level
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
d: BPM
e: Delay Base Note
e: Times
The delay time is the duration of “Times” number of “Delay Base Note” note
values at the “BPM” tempo (or if “BPM” is set to MIDI, the tempo determined
by MIDI Clock).