Managing files on disk |915
Loading data from i-Series instruments
Pa1000 is compatible with the Styles of the older KORG i-Series instruments.
You can load them as if they were ordinary Pa1000 data.
1 Copy the old i-Series data into an USB device, or transfer them to the internal
memory of Pa1000.
2 Go to the Media > Load page.
3 Use the Device pop-up menu to select the device containing the i-Series
data.
4 If you are reading an i30 file, select the SET folder, then touch the Open
button.
5 Select the STY folder.
6 At this point, you can load the whole STY folder, or open it and choose a
single Style.
▪ To load the whole folder, touch the Load button.
▪ To load a single Style, touch Open in the display to open the STY folder. Since
a conversion will be started at this point, please wait some seconds for the
operation to be completed.
Select the Style to load, then touch Load. You will be prompted to select a
target location in memory. Once the target location is selected, touch Load
to load the Style. The ‘Are you sure?’ message will appear. Touch OK to con-
firm.
Please note that loading a whole SET folder from an i30 file may take some
time due to format conversion.
7 Go to the Style Play mode, and select (one of) the loaded Style. Adjust the
Tempo value, then choose the Write Current Style Settings command from
the page menu to write changes.
8 Due to the difference in Sounds, you will probably want to make some ad-
justments to the old Styles, once they are loaded in Pa1000 (changing the
Sound, Volume, Pan, Tempo, Drum Mapping, Wrap Around…).
9 To make the Sound assignment to the Style tracks effective, be sure the
Original Style Sounds parameter is not checked (Volume pane, Style track
view).
10 Save the Style Settings again, by choosing the Write Current Style Settings
command from the page menu.
To Next Page
Loading...
Need help?
General
