Korg PS60 - MIDI;Osc

Timbre Param (Timbre Parameters) MIDI/OSC
7
MIDI/OSC
Main Timbres (A. Piano–Synth):
Sub Timbres (A. Piano–Synth):
HereyoucanadjustsettingsforeachtimbreʹsMIDItrans‐
missionstatus,channel,andoscillatormode.
MIDI
Status [INT, EXT, EX2]
ThisparametersetswhethertheTimbrecontrolstheinter‐
nalsounds,orexternalMIDIdevices.
INT:Thetimbrewillsound,andwillalsosoundinresponse 
toMIDImessagesfromanexternalMIDIdevice.MIDIdata
willnotbetransmitted.
EXT:Thetimbrewillnotsoundevenifitreceivesmessages
fromaco
ntroller,butMIDIdatawillbetransmittedtoexter‐
naldevices.
EX2:The“BankSelect(WhenStatus=EX2)”(settableonly
viatheeditor,page7)LSBvalueandMSBvaluewillbe
used.InsteadoftheA–Dbanknumbersthatcanbeselected
fromthePS60itself,thebanknumberspecifiedfo
r“Bank
Select”willbetransmittedviaMIDI.Otheraspectsarethe
sameasforEXT.
TheʺProgramSelectʺindicationshownonthePS60itselffor
performanceandperformanceeditmodeswillchangeas
followsaccordingtotheʺStatusʺsetting.Theillustration
shownhereisforaperformance.
"Status" INT
Timbre category
Index number: program name
"Status" EXT
Timbre's MIDI channel
Program's bank number: program name
"Status" EX2
Timbre's MIDI channel
Program change number: [MSB/LSB]
MIDI Ch. (MIDI Channel) [01...16, Gch]
ThisparameterallowsyoutosettheMIDItransmit/receive
channelforeachtimbre.
Gch:Thetimbrewillusethechannelthathasbeenselected
astheglobalMIDIChannel(page72).
WhenStatusisINT,MIDImessageswillbereceivedonthe
channelthatyouspecifyhere.Ifthissettingisthesameas
th
eglobalMIDIchannel,theinternaltonegeneratorwill
soundaccordingtotheinternalsettings.IfthisissettoEXT
orEX2,playingthePS60willtransmitMIDImessageson
theMIDIchannelthatʹsspecifiedhere.(Messageswillalso
betransmittedsimultaneouslyontheglobalMIDIchannel.)
Ifasetting01–16matchestheglobalMIDIchannel,“G”is
shownattheright.
Bank MSB [000..127]
Bank LSB [000..127]
Thisspecifiesthebanknumberthatistransmittedwhen
ʺStatusʺisEX2.TheupperlineistheMSBandthelowerline
istheLSB.ThissettingisignoredifʺStatusʺisotherthan
EX2.
OSC
Force OSC Mode [PRG, Poly, Mono, LGT]
ThisletsyouoverridetheProgram’sstoredVoiceAssign
Modesettings,ifdesired.
PRG:TheProgram’sstored“VoiceAssignMode”(page16)
settingswillbeused.
Poly:Thetimbrewillplaypolyphonically,regardlessofthe
Program’ssettings.
Mono:Thetimbrewillplaymonophonically,regardlessof
theProgram’ssettings.
Legt(Legato):Thetimbrewillso
undmonophonically,and
willplaylegatoaccordingtotheProgram’ssetting.
MIDI IN/
USB B
INT
MIDI OUT/
USB B
EXT, EX2
Tone
generator