Korg PS60 - Page 31

OSC/Pitch OSC1 Multisample
27
Range (Crossfade Range) [Off, 1...127]
ThissetstherangeofvelocitiesoverwhichHigh willfade
intoMid‐High,goingupfromthe“BottomVel.”
Forinstance,ifthe“BottomVel.”issetto64,andthe
“Range”issetto20,Mid‐Highwillstarttofadeinatveloci‐
tiesof84andbelow.
Whenve
locitiesarewithinthe“Range,”theOscillatorwill
usetwiceasmuchpolyphonyasitwouldnormally.
Note:Youcanonlyfadebetweentwozonesatonce.
Curve [Linear, Power, Layer]
Thiscontrolsthevolumecurveofthecrossfade.Linearand
Power(shortforEqualPower)letyoufine‐tunethewaythat
thetwoMultisamplesmixtogether;oneortheothermaybe
moreappropriateforagivenpairofMultisamples.Layer,
truetoitsname,letsyoulayerthetwo Multisamples
togetherwithoutanycrossfading.
Linearmeansthatthetwosampleswilleachbeat50%of
theirfullvolumeinthemiddleofthecrossfade.Sometimes,
thismay createadipinthevolumelevel;ifso,tryusing
Powerinstead.
Power,shortforEqualPower,meansthatthetwosamples
wil
leachbeataround70%oftheirfullvolumeinthemid‐
dleofthecrossfade.Sometimes,thismaycreateabumpin
thevolumelevel,inwhichcaseyoumighttryselectingLin‐
earinstead.
LayermeansthatthetwoMultisampleswillbelayered
together,bothatfullvo
lume,fortheentirerangeofthe
crossfade.
Crossfade Curves
Mid High, Mid-Low, Low
Thesearethesettingsforthesecond,third,andfourth
velocityzones.TheparametersforMid‐HighandMid‐Low
areexactlythesameasthoseforHigh,asdescribedabove.
TheparametersforLowarealsosimilartothoseforHigh,
exceptthatLowhasnosettingsfor“BottomVel.”(whichis
alwaysfixedat1),“Range,”or“Curve.”
Bottom Velocity = 64
Xfade Range = 20
Curve = Linear
84
Xfade
Power
Xfade
Layer
Linear
Volume
MS1
MS2
Velocity
Volume
MS1
MS2
Velocity
Volume
MS1
MS2
Velocity
Xfade