4
LeeBoy 6150 Conveyor Paver 4-13
Operation
If the operator does not wish to complete a Parked Re-
generation, click the soft key. This action cancels
Regen, removes the pop-up message, and takes the
operator back to the Gauge Screen.
To perform a regeneration:
• Ensure the machine is in neutral and parking
brake applied. The coolant temperature must be
in operating range, typically 155° -160 F°. Set the
engine to low idle.
• Once these conditions are met, a blue screen
message will appear. (Figures 4-26 and 4-27).
• Using the Up/Down Arrow, scroll down through
the entire message and press the Request Regen
Button.
Figure 4-26. Parked Regeneration Blue Screen
Continue to monitor surrounding areas
during the process. If unsafe conditions develop,
shut the unit off immediately.
DO NOT ATTEMPT TO OPERATE
THE UNIT, CHANGE ENGINE RPM OR MOVE FROM
PARK/NEUTRAL WHILE REGEN IS OCCURRING. This
will abort the Regeneration process and require you
to start the process over.
Some messages require using the UP/DOWN soft keys
to scroll through the entire message (Figures 4-24 and
4-25) .
Figure 4-24. Regen Caution Message Popup Screen
Example Requiring Use of UP/DOWN Soft Keys
Figure 4-25. Parked Regeneration Instructions
Screen
To Next Page
Loading...
