4-12 LeeBoy 6150 Conveyor Paver
Operation
Regeneration Messages
Parked Ready Regen
The machine should be maintained in an operating
condition so the DPF can automatically regenerate. (A
complete listing of Fault Codes is shown in Trouble-
shooting, Section 5.)
The operator may experience a Regen Caution mes-
sage on the controller screen (Figure 4-23). The mes-
sage requires an active response by the operator, so it
is important that the operator reads the entire message
as it may display instructions to perform regeneration.
NOTE: The machine must be in park and neutral with
a DPF level of 2 or higher to perform Parked
Regeneration.
Figure 4-23. Regen Caution Message Popup Screen
EXHAUST TEMPERATURES WILL BE
EXTREMELY HIGH. BE SURE EXHAUST WILL NOT
COME INTO CONTACT WITH ANY COMBUSTIBLE
MATERIALS.
NOTE: During the regeneration, the Engine Speed
will increase and there may be a noticeable
sound difference. The HEST Lamp will appear
during the process.
Date and Time Setting
Use the UP/DOWN soft keys and stop the cursor (>)
next to the action item Date or Time. (Figure 4-22)
• Press the select ( ) soft key to initiate change to
the month value. Use the (+/–) soft keys to increment
or decrement the number.
• Use the DOWN arrow to reach the day value and
year value, using the +/– soft keys to make changes.
NOTE: A reboot is required for changes to the Date
Setting to take effect.
Figure 4-22. Time Setting Screen
NOTE: Pressing the “X” button closes the pop-up
messages.
To Next Page
Loading...
