1
2
Adapters
Brackets
Adapter connector (slot 4)
Adapter connector (slot 5)
Expansion-slot covers
Figure138.Adapterinstallation
Step7.Rotatetheretentionbrackettothecloseposition.
Step8.Connectanyrequiredcablestotheadapter.
Attention:
•Whenyouroutecables,donotblockanyconnectorsortheventilatedspacearoundanyof
thefans.
•Makesurethatcablesarenotroutedontopofcomponentsthatareundertheriser-card
assembly.
•Makesurethatcablesarenotpinchedbytheservercomponents.
Step9.Performanyconfigurationtasksthatarerequiredfortheadapter.
Step10.Reinstallthetopcover(see“Replacingthetopcover”onpage151).
Step11.Slidetheserverintotherack.
Step12.Reconnectthepowercordsandanycablesthatyouremoved.
Step13.Turnontheperipheraldevicesandtheserver.
Replacinganadapterinthereartwohard-disk-drivekit
Usethisinformationtoreplaceanadapterinthereartwohard-disk-drivekit.
Toinstallanadapter,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page297
.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercordsandallexternalcables.
Step3.Removetheservertopcover(see“Removingthetopcover”onpage149).
Step4.Removethereartwohard-disk-drivekit(see“Removingthereartwohard-disk-drivekit”on
page207).
Step5.1Slidetheretentionbracket;then,2rotateittotheopenposition.
Chapter5.Installing,removing,andreplacingcomponents203
To Next Page
Loading...
