•Onepower/configurationcable(150mm)
•Onepower/configurationcable(230mm)
•OneMini-SASHDY-cable(rightangle,905/950mm)
•OneMini-SASHDY-cable(580/590mm)
Notes:
1.The8x2.5-inchhot-swapHDDassemblykitincludingstructuralpartsandTier1parts.
2.Youwillnotuseallcablesthatcomewiththeoptionkit,somecablesmayberedundantdepending
onyourconfiguration.
Toinstalla8x2.5-inchhot-swapHDDassemblykit,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page297.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercordsandallexternalcables,
ifnecessary.
Step3.Removethetopcover(see“Removingthetopcover”onpage149).
Step4.Removethetwo4-drivefillerpanels.
Figure274.Fillerpanels
Step5.Toobtainmoreworkingroom,removethefancage(see“Removingthefancageassembly”on
page178).
Step6.Pulltheharddiskdrivesorfillersoutoftheserverslightlytodisengagethemfromthebackplanes.
Formoreinformation,(see“Removingahot-swapharddiskdrive”onpage158).
Step7.Installthenewbackplaneinslot2orslot3dependingonyourconfiguration.Insertthebackplane
tabsintoslotsonthebottomofthecageandpushthebackplaneforwardintothereleaselatch(on
topofthebackplanecage)untilthebackplaneislockedinplace.
Note:Youcanconnectthecablestothedrivebackplanebeforeinstallingthebackplaneontothe
cageoryoucanconnectthecablesafteryouinstallthebackplane,ifthatiseasierforyou.
Chapter5.Installing,removing,andreplacingcomponents305
To Next Page
Loading...
