Attention: Tighten and remove the screws with a torque screwdriver sets to the proper torque. For
reference, the torque required for the screws to fully tighten/removal is 0.5±0.05 newton-meter, 4.5
±0.5 pound-inch.
Figure 235. Installing a GPU to the SXM GPU board
Step 3. Proceed to install the SXM GPU board.
Attention: Apply thermal grease only when the SXM GPU board is installed in GPU tray
After you finish
1. Reinstall the SXM GPU board. See “Install the SXM GPU board” on page 305.
2. Reinstall the Lenovo Neptune
TM
liquid-to-air (L2A) hybrid cooling module. See “Install the Lenovo
Neptune(TM) liquid-to-air (L2A) hybrid cooling module” on page 289.
3. Reinstall the retimer assembly. See “Install the retimer assembly” on page 322.
4. Reinstall the front I/O expansion board module. See “Install the front I/O expansion board module” on
page 277.
5. Reinstall the network adapter. See “Install a network adapter” on page 180.
Chapter 4. Hardware replacement procedures 301
To Next Page
Loading...
