EasyManuals Logo

Lenze 8200 vector series Mounting Instructions

Lenze 8200 vector series
Go to English
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Safety instructions
Residual hazards of Lenze controllers
2
113
EDK82EV903 DE/EN/FR 5.1
ƒ Controllers can cause a DC current in the PE conductor. If a residual current device
(RCD) or a fault current monitoring unit (RCM) is used for protection in the case of
direct or indirect contact, only one RCD/RCM of the following type can be used on
the current supply side:
Type B for the connection to a three−phase system
Type A or type B for the connection to a single phase system
Alternatively another protective measure can be used, like for instance isolation from
the environment by means of double or reinforced insulation, or isolation from the
supply system by using a transformer.
ƒ If you use the Selection of direction of rotation" function via the digital signal
DCTRL1−CW/CCW (C0007 = 0 ... 13, C0410/3 ¹ 255):
In the event of an open circuit or failure of the control voltage, the drive can
change its direction of rotation.
ƒ If you use the function "flying restart circuit" (C0142 = 2, 3) for machines with a low
moment of inertia and low friction:
After controller enable at standstill, the motor can start for a short time or change
its direction of rotation for a short time.
Device protection
ƒ Frequent switching of the supply voltage (e.g. inching mode via mains contactor)
can overload and destroy the input current limitation of the controller:
Wait for at least 3 minutes between two starting operations.
ƒ Only switch contactors in the motor cable when the controller is inhibited.
Otherwise ...
monitoring functions of the controller can be activated.
the controller can be destroyed under unfavourable operating conditions.
Motor protection
ƒ For some controller settings, the connected motor may overheat (e.g. when
operating the DC injection brake or a self−ventilated motor at low speed for longer
periods).
Using an overcurrent relay or a temperature monitoring device provides a large
degree of protection against overload.
We recommend to use PTC thermistors or thermal contacts for motor temperature
monitoring. (Lenze three−phase AC motors are equipped with thermal contacts
(NC contacts) as standard)
PTC thermistors or thermal contacts can be connected to the controller.
ƒ Drives can attain dangerous overspeeds (e.g. setting of high output frequencies with
motors and machines not qualified for this purpose).

Table of Contents

Other manuals for Lenze 8200 vector series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenze 8200 vector series and is the answer not in the manual?

Lenze 8200 vector series Specifications

General IconGeneral
CategoryDC Drives
Overload capacity150% for 60 seconds
Protection classIP20
Mains voltage380V to 480V AC
Control methodVector control
Communication optionsCANopen
Protection featuresOvercurrent, overvoltage, undervoltage, overtemperature, short circuit
Humidity≤ 95% relative humidity, non-condensing
Series8200 vector

Related product manuals