Lenze 8600 series - Page 135

-
Code Name Parameter
(Factory setting is printed in hold)
CO30’ Constant for -l-
512 pulses/Hz or Incrementslrev.
digital -2- 1024 pulses/Hz or increments/rev.
frequency -3- 2048 pulses/Hz or increments/rev.
Acceptance
SH + PRG
loutput x9 l-4- 4096 pulses/Hz or increments/rev.
!
CO34 Master current -O- O...20mA
-l- 4...20mA l
SH + PRG
CO36 Voltage for 0% 0 % IO.1 %} 40% ON-LINE
DC-injection
brake
Co38 Preselection: -l- JOG 1 SH + PRG
JOG
-2- JOG 2
frequency . . .
-15- JOG 15
CO39 Setpoint for 50.OHz -480 Hz
11 Hz1
-100 Hz ON-LINE
CO38
-100 Hz (0.1 Hz) +lOO Hz
CO40 I Controller I-O-
+100 Hz
11 Hz1
480 Hz)
Controiler inhibitetiinhibit ISH + PRG
enable I-l- Controller enabled/enable
I
CO41 1 Direction of I-O-
Main setpoint unchanged/
ISH + PRG
rotation
accept unchanged
-l- Main setpoint invertetiinvert
CO42 Quick stop -o- Quick stop no activeideactivate
-l-
Quick stop active/activate
CO43 TRIP reset -o- Reset fault
INFO: Only with LECOM
CO45
Enable -O- Setpoint 1 acivelactlvate
JOG setpoint -1-
Setpoint JOG 1 activelactivate
.
-15- Setpoint JOG 15 activelactivate
SH + PRG
SH + PRG
SH + PRG
CO46 Setpoint 1 1
standardized setpoint selection: ON-LINE
-100.0 % (0.1 %) +lOO.O%
INFO: Refers to maximum field frequency
absolute setpoint seiectlon:
0.00 Hz
(0.01 Hz} 100.00 Hz
100.0 Hz
IO.1 Hz) 480.0 Hz
INFO: adjustable range: -fdmax bis +fdmax
CO48 Enable DC- -0.
DC-injection brake inhibited/deactivate SH + PRG
injection brake -1-
DC-injection brake enabledlactivate
CO49
Display x.x %
setpoint 2
INFO: Actual-value display (setpoint 2/actual radius
val ue)
-fdmax to +fdmax
CO50 output x.x Hz
frequency
INFO: Actual-value display
Co51 Act. PI- x.x %IHz
controller
value
INFO: Actual-value display (speed/dancer-
position/torque setpoint)
CO52
Motor voltage x.x V
INFO: Actual-value display
Co53 DC-bus
x.x v
voltage
INFO: Actual-value display
sec
page
35
56
32,
37
33
33
50
50
50
148
33
56
32
58
101
30
101
101
tour
iettings
133