Parameter setting
General information
7-1
l
EDSVS9332S-D11 EN 3.0
Teil D1.1
7 Parameter setting
7.1 General information
z The controller can be adapted to your application by setting parameters. A detailed
description of the function can be found in the function library.
z The function parameters are stored as numerical codes:
– Codes are marked in the text with a ”C”.
– The code table provides a quick overview of all codes. The codes are sorted according to
their numbers and can be used as reference.
Parameter setting with the keypad XT or PC
z For more detailed information about parameter setting with the keypad see the following
chapters
z For more detailed information about parameter setting with the PC see the Operating
Instructions for the communication module LECOM-A/B (RS232/RS485) EMF2102IB-V001.
z Keypad and PC can also be used to
– control your controller (e. g. inhibit and enable)
– select setpoints
– display operating data
– transfer parameter sets to other controllers
Parameter setting with a bus system
z More detailed information about bus modules can be found in the corresponding Operating
Instructions.
To Next Page
Loading...