Lenze EVS 9300 series - Description of the Display Element

Parameter setting
Parameter setting using the keypad
7-3
l
EDSVS9332S-D11 EN 3.0
7.2.2 Description of the display element
YZ
y
z
T V
S U
dABbc
p
SHPRG
Para
Code
Menu
0050
00
50.00_Hz
MCTRL-NOUT
0
1
3
4
5
6
7
8
2
29371BC002

Status display basic device

Display Meaning Explanation

Ready for operation

Pulse inhibit active Power outputs inhibited

Adjusted current limitation is exceeded in motor-mode or
generator-mode

Speed controller 1 in limitation Drive torque-controlled
(active only when operating with the basic controllers of
the 9300 series)

Active fault

Adoption of parameters

Display Meaning Explanation
 Parameters are adopted immediately Basic device operates immediately with the new
parameter value
SHPRG  Parameter must be confirmed with  Basic device operates with the new parameter value,
after it was confirmed
SHPRG In case of controller inhibit the parameter must be c onfirmed
with 
Basic device operates with the new parameter value,
after the controller has been enabled
none Display parameter Change not possible

Active level

Display Meaning Explanation
Menu Menu level active Select main menu and submenus
Code Code level active Select codes and subcodes
Para Parameter level active Change parameters in the codes or subcodes
none Operation level active Display operating parameters

Short text

Display Meaning Explanation
alphanumerical
Contents of menus, meaning of codes and parameters
a
l
p
h
a
n
u
m
e
r
i
c
a
l
In operation level display of C0004 in % and active fault

Number

active level Meaning Explanation
Menu level Menu number Display only active when operating with the basic
device series 8200 vector or 8200 motec
Code level Four-digit code number

Number

active level Meaning Explanation
Menu level Submenu number Display only active when operating with the basic
device series 8200 vector or 8200 motec
Code level Two-digit subcode number