Lenze EVS 9300 series - Description of the Function Keys

Parameter setting
Parameter setting using the keypad
7-4
l
EDSVS9332S-D11 EN 3.0

Parameter value

Parameter value with unit

Cursor

In the parameter level the number above the cursor can be directly changed

Function keys

For description see the following table
7.2.3 Description of the function keys
 Note!
Pressthekeycombinationswith:
Press  and keep it pressed, then additionally press the second key.
Press key
Function 3
P
r
e
s
s
k
e
y
Menu level Code level Parameter level Operation level

Change to the parameter level Change to the operation level Change to the code level

Load predefined configurations
in the menu ”Short setup”
1)
Accept parameter, if SHPRG 
or SHPRG is displayed


Change between menu points Change code number Change number above cursor


Change quickly between menu
points
Change code quickly
Change number above cursor
quickly

C
h
a
n
g
e
b
e
t
w
e
e
n
m
a
i
n
m
e
n
u
s
u
b
m
e
n
u
s
a
n
d
c
o
d
e
l
e
v
e
l
Cursor to the right

Change be
t
ween main menu, submenus and code level
Cursor to the left

Cancel function of key , the LED in the key disappears

Inhibit the controller, LED in the key lights up

Reset fault (TRIP-Reset): 1. Remove cause of malfunction
2. Press

3. Press 
1)
only active when operating with the basic device series 8200 vector or 8200 motec