Lenze EVS 9300 series - Activation of Password Protection

Parameter setting
Parameter setting using the keypad
7-9
l
EDSVS9332S-D11 EN 3.0
7.2.7 Activation of password protection
 Note!
z If the password protection is activated (C0094 = 1 ... 9999) only the user menu
can be freely accessed.
z Enter a password before you go to other menus. Therefore, the password
protection is inactive until you enter a new password.
z Please observe that also the password protected parameters will be overwritten
when parameter sets are transferred to to other basic devices. The password will
not be transferred.
z Do not forget your password! If you cannot remember the password, it can only
be reset via PC or a bus system.
Activate password protection
Step Keys Action
1. Select menu ”USER-Menu”

Change to the user menu using the arrow keys
2. Change to code level

Display code C0051 ”MCTRL-NACT”
3. Select C0094

Display code C0094 ”User password”
4. Change to parameter level

Display ”0” = no password protection
5.
Password setting
A)

Select password (1 ... 9999)
B)

Confirm password
6.
Change to code level
A)

Display of operating level
B)

Display C0094 and ”User password”
7. Change to menu ”USER-Menu”

The password protection is active now.
You can quit the user menu only if you re-enter the password and confirm with
.
Cancel password protection
1. Change to code level in the user menu

2. Select C0094

Display code C0094 ”User password”
3. Change to parameter level

Display”9999” = password protection active
4.
Password entry
A)

Set valid password
B)

Acknowledge
The password protection is deactivated by re-entering the p assword.
5.
Change to code level
A)

Display of operating level
B)

Display C0094 and ”User password”
The password protection is inactive now. All menus are accessible again.