Lenze EVS 9300 series - Index

Index
abc
14-3
L
EDSVS9332S EN 3.0
14.1 Index
A
Absolute position determination, 8-32
Absolute value generator(ABS), 9-51
Acceleration and deceleration times, 8-5
- Additional, 8-5
Acceleration time, 9-255 , 9-263
Actual motor current, 9-257
Actual motor voltage, 9-257
Actual phase integrator (PHDIFF), 9-181
Actual speed value, 9-257
Actual value display, 6-3
Addition block (ADD), 9-52
Additional setpoint, 8-5 , 9-167 , 9-257
- Correction signal, 8-5
Additional torque setpoint, 8-7 , 9-138
Aggressive gases, 4-11
Analog input (AIN), 9-58
Analog inputs
- Set master current with jumper, 4-45
- Set master voltage with jumper, 4-45
Analog output (AOUT), 9-65
Analog signals, connection, 4-44
AND op eration (AND), 9-60
Application, as directed, 1-3
Application as directed, 1-3
Application examples, 12-1
- Speed control, 12-2 , 12-5 , 12-7 , 12-10 , 12-12
Arithmetic blocks (ARIT), 9-67
Assembly, with fixing rails or brackets, 4-12
Automatic adjustment H30, 9-228
Automation interface, 4-56
Automation interface (AIF-IN), 9-53
Automation interface (AIF-OUT), 9-56
B
basic function, 9-254
Baud rate, system bus (CAN)
Braking unit, 4-36
Bus connection, 4-54
C
Cable cross-sections, 3-7 , 4-26
- Mains connection, 4-26
- Motor cable, 4-31
Cable resistance, 4-55
Cable specifications, 4-22
Cable type, 4-55
CAN bus identifier, 9-265
CANopen, 4-54
Capacitance per unit length, 4-55
Cascading factor, 8-18 , 8-21
CE marking, 1-4
Change parameters, Keypad EMZ9371BC, 7-5 ,
7-6 , 7-9
Changeover switch for analog signals (ASW),
9-69
Changing parameters, Keypad EMZ9371BC, 7-7 ,
7-8
Characteristic function (CURVE), 9-88
CINH at the master, 8-15
CINH at the slave, 8-18 , 8-21
Code table, explanation of, 9-253
Code table for controllers, 9-253
Collective shield sheet, 4-39
Commissioning, 5-1
Communication error CE0, 9-224
Communication times, system bus (CAN), 4-54
Comparator (CMP), 9-78
Configuration, 8-1
- Basic configurations, 8-2
- Code table, 9-253
- Function blocks, 9-39
- Function library, 9-39
- Global Drive Control, 8-1
- Monitoring, 9-219
- Reactions, 9-219
- Set reactions, 9-220
- Table of attributes, 9-301