Lenze EVS 9300 series - Page 496

Index
abc
14-4
L
EDSVS9332S EN 3.0
Conformity, 3-2
Connection
- Analog inputs (X6), 4-44
- Braking unit, 4-36
- Digital inputs (X5), 4-41
-Mains, 4-24
- Motor, 4-27
Contouring error P03, 9-242
Control cables, 4-39
- Connection, 4-40
Control characteristic, 9-176
Control connections, 4 -39
Control of the drive controller (DCTRL), 9-92
Control terminals, protection against inverse
polarity, 4-40
Controller, 1-1
- Application as directed, 1-3
- Labelling, 1-3
- Protection, 4-21
- Status indications, 6-1
Controller inhibit, 8 -7
Controller inhibit (CINH), 9-94
Cooling air, 4-11
Current controller, 9 -138
- optimisation for rotor position adjustment, 5-6
Current derating, 6-5
Current operated protections, 4-19
CW-CCW-QSP link (R/L/Q), 9-190
D
Data, keypad EMZ9371BC, 7-12
DC-bus operation, 4-37
DC-bus voltage, 9-257
Dead band(DB), 9-91
Deceleration time, 9-255 , 9-263
Definitions, 1-1
Degree of pollution, 3-2
Delay element (PT1), 9-189
Delay elements (DIGDEL), 9-115
Derivative-action element (DT1), 9-120
Device control, 9-254
Diagnostics with, keypad EMZ9371BC, 7-10
Dig-Set monitoring Sd3, 9-247
Digital frequency output (DFOUT), 9-100
Digital frequency processing (DFSET), 9-110
Digital frequency ramp function generator
(DFRFG), 9-104
Digital inputs (DIGIN), 9-118
Digital outputs (DIGOUT), 9-119
Digital signals, connection, 4-41
Digital status signals (STAT), 9-202
Dimensions, 3-9
- Standard units, 4-12
Display, actual values, 6-3
Display elements, keypad EMZ9371BC, 7-3
Disposal, 1-3
Drive system, 1-1 , 8-11
E
Earth fault OC2, 9-233
EC Directives, 1-4
- Electromagnetic compatibility, CE-typical drive system, 1-6
- electromagnetic compatibility, 1-6
- Low voltage, 1-5
- Machines, 1-8
Edge evaluation (TRANS), 9-216
Electrical data
- 200% overcurrent, 3-5
- Types 9321 to 9325, 3-4
- Types 9326 to 9332, 3-6
Electrical installation
- Control connections, 4-39
- Power connections, 4-23
Electrical shaft, 8-24
EMC, 3-2
- Assembly, 4-57
- Earthing, 4-57
- Filters, 4-57
- Shielding, 4-57
Enclosure, 3-2
Encoder, connection, 4-49
External error EER, 9-225