Lenze EVS 9300 series - Page 497

Index
abc
14-5
L
EDSVS9332S EN 3.0
F
Failure of a motor phase LP1, 9-229
Fast mains recovery (KU), 9-154
Fault analysis, 10-3
Fault in the resolver driver H056, 9-226
Fault indication, reset, 10-10
Fault messages, 10-6
Fault reset, 8-8
Features, 3-1
- CAN on board, 4-54
field controller, 9-258
Field w eakening, 9-144
Fieldbus module, 9-53
Fixed setpoints (FIXSET), 9-129
Flipflop (FLIP), 9-131
Flying synchronising, 8-25
Following error limit, 8-25
Free control codes, overview, 9-50
Free piece counter (FCNT), 9-121
Free space, 4-11
Freedigital outputs (FDO), 9-122
Freely assignable input variables (FEVAN), 9-124
Function blocks, 9-39 , 9 -48
- Absolute value generator(ABS), 9-51
- Actual phase integrator (PHDIFF), 9-181
- Addition block (ADD), 9-52
- Analog input (AIN), 9-58
- Analog output (AOUT), 9-65
- AND operation (AND), 9-60
- Arithmetic blocks (ARIT), 9-67
- Automation interface (AIF-IN), 9-53
- Automation interface (AIF-OUT), 9-56
- Changeover switch for analog signals (ASW), 9-69
- Characteristic function (CURVE), 9-88
-Comparator(CMP), 9-78
- Configuration code, 9-41
- connect, 9-42
- control of drive controller (DCTRL)
controller inhibit (CINH), 9-94
TRIP-SET, 9-94
- Control of the drive controller (DCTRL), 9-92
parameter set changeover (PAR), 9-96
quick stop (QSP), 9-93
- control of the drive controller (DCTRL)
operation inhibit (DISABLE), 9-94
TRIP-RESET, 9-95
- CW-CCW-QSP link (R/L/Q), 9-190
- Dead band(DB), 9-91
- Delay element (PT1), 9-189
- Delay elements (DIGDEL), 9-115
- Derivative-action element (DT1), 9-120
- Digital frequency output (DFOUT), 9-100
- Digital frequency processing (DFSET), 9-110
- Digital frequency ramp function generator (DFRFG), 9-104
- Digital inputs (DIGIN), 9-118
- Digital outputs (DIGOUT), 9-119
- Digital status signals (STAT), 9-202
- Display code, 9-41
- Edge evaluation (TRANS), 9-216
- Establish connections, 9-44
- Fixed setpoints (FIXSET), 9-129
- Flipflop (FLIP), 9-131