Lenze EVS 9300 series - Multi-Axis Synchronisation (SYNC1)

Function library
Function blocks
9.2.64 Multi-axis synchronisation (SYNC1)
9-208
L
EDSVS9332S-D11 EN 3.0
9.2.64 Multi-axis synchronisation (SYNC1)
Purpose
Synchronises the control program cycle of the drives to the cycle of a master control.
S Y N C 1
S Y N C 1 - I N 1
S Y N C 1 - I N 2
S Y N C 1 - I N 3
S Y N C 1 - S T A T
C 1 1 2 7
C 1 1 2 8
C 1 1 2 9
C 1 1 2 4
C 1 1 2 5
C 1 1 2 6
X 5 - E 5
S Y N C 1 - O U T 1
S Y N C 1 - O U T 2
S Y N C 1 - O U T 3
C L K
X 4
C 1 1 2 3 / 1
C 1 1 2 3 / 2
C 1 1 2 1 / 2
C 1 1 2 2
C 1 1 2 1 / 1
C 1 1 2 0
C 0 3 6 3
Signal Source Note
Name Type DIS DIS format CFG List Lenze
SYNC1-IN1 a C1127 dec [inc] C1124 1 1000 -
SYNC1-IN2 ph C1128 dec [inc] C1125 3 1000 -
SYNC1-IN3 a 1129 dec C1126 1 1000
SYNC1-STAT d - - - - - After the synchronisation is completed,
SYNC1-STAT switches to HIGH.
If the synchronisation is quit,
SYNC1-STAT switches to LOW.
SYNC1-OUT1 phd - - - - - Cannot be used for accurate speed/phase
difference transmission
SYNC1-OUT2 ph - - - - - With interpolation, for cyclically
synchronised position information
SYNC1-OUT3 a - - - - - With interpolation, for analog values