Configuration
Basic configurations
8-3
L
EDSVS9332S-D11 EN 3.0
Second digit
Defines the additional function which expands the basic function.
Configuration C0005 Additional function
x0xx No additional function
x1xx Brake control via digital output X5/A2
x9xx In case of quick stop the complete connection of drives is phase-controlled to zero speed
Third digit
Defines whether the volta ge of the analog and digital control inputs is to be supplied internally or externally.
Configuration C0005 Supply voltage
xx0x External
xx1x Internal via terminal X5/A1 and X6/63
Fourth digit
Defines the controller interface to read in certain control signals (e. g. speed setpoint).
Configuration C0005 Interface
xxx0 Control terminals
xxx1 RS 232, RS 485 or optical fibre
xxx3 InterBus-S or Profibus
xxx5 System bus (CAN)
Tip!
The most important codes for parameter setting of the basic configuration can be found in the
Global Drive Control program and in the keypad in the menu items ”Short setup”.
To Next Page
Loading...