Function library
Function blocks
9.2.41 Mains failure control (MFAIL)
9-151
L
EDSVS9332S-D11 EN 3.0
Stop!
This setpoint must be below the threshold of any brake unit which may be connected.If a connected
brake unit is activated, the drive is braked with the maximum possible torque (Imax). The desired
operating behaviour is lost.
5. Set the setpoint on which the DC bus voltage is to be controlled:
– Set the setpoint to approx. 700 V (C0472/19 = 70 %).
To Next Page
Loading...