EasyManua.ls Logo

Lenze EVS 9300 series - Page 299

Lenze EVS 9300 series
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Function library
Function blocks
9.2.48 Oscilloscope function (OSC)
9-173
L
EDSVS9332S-D11 EN 3.0
Function DescriptionSelectionCode
Trigger delay The trigger delay defines when to begin with the saving of the measured values with
regard to the trigger time.
C0737
-100.0 % ... 0 %
Negative trigger delay (pre-triggering)
Defines a percentage of the whole memory content. This part of the memory
content is filled with measured values before the triggering (see Fig. 9-126).
0 % ... 999.9 % Positive trigger delay (post triggering)
Defines a percentage of the whole memory content. The saving of the measured
values after triggering is delayed by this part of the memory content (Fig. 9-125).
Sampling period C0738 1 ms ... 10 min Setting of the sampling period
The sampling period is the time between two measurements
The measurements are carried out simultaneously for all channels (e. g. is
measured value at channel 1 is measured at the same time as a measured value
at channel 2, 3 or 4.
The sampling period can be set in steps of 1, 2 and 5.
Number of
Channels
C0739 Number of channels used for measurements.
Read data
The code is required if the GDC is not used for the visualisation.
R
e
a
d
d
a
t
a
memory
C0740/1 0 ... 16383 Defines the starting point for reading the data memory and thus enables the memory
array to be deliberately accessed.
In order to read the data memory b it by bit (e. g. reading only the measured value
of a channel or reading with reduced memory depth), the starting point can be
changed.
C0740/2
1 Enable “Read memory”
Enables the access to the memory to read the data
0 Inhibit “Read memory”
Inhibits the access to the memory. The access must be inhibited after every
reading of the data
Information
Provides information on the function block
I
n
f
o
r
m
a
t
i
o
n
about the
f
t
i
b
l
k
C0741/1 Version of the function block (e. g. 120: Version 1.20)
function block
C0741/2 Data memory size (1024 ... 16384 bytes)
C0741/3 Data width of the measured values (1 byte / 2 bytes)
C0741/4 Number of the available measuring channels (1 ... 4)

Table of Contents

Related product manuals