Installation
Electrical installation
4.2.13 Connection of feedback systems
4-49
L
EDSVS9332S-B EN 3.0
4.2.13.2 Encoder connection to X8 or X9
Stop!
Please observe the supply voltage of the encoder used. If C0421 is set too high, the
encoder may be destroyed.
An incremental encoder or a sin/cos encoder can be connected to this input.
z The controller supplies the encoder with voltage.
z Use C0421 to adjust the supply voltage V
CC5_E
(5 V ... 8 V) for the encoder to compensate the
voltage drop [ΔU] in the encoder cable, if necessary:
ΔU ≈ 2 ⋅ Cable length [m] ⋅
Cableresistance[Ω]
[m]
⋅ I
Encoder
[A]
Note!
Use prefabricated Lenze system cables to connect the encoder.
To Next Page
Loading...