LevelOne GEL-1061 - Page 50

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 50 –
Static 157
Add Configures static entries in the address table 157
Show Displays static entries in the address table 157
MAC Notification 162
Configure Global Issues a trap when a dynamic MAC address is added or removed 162
Configure Interface Enables MAC authentication traps on the current interface 162
Spanning Tree 165
Loopback Detection Configures Loopback Detection parameters 167
STA Spanning Tree Algorithm
Configure Global
Configure Configures global bridge settings for STP, RSTP and MSTP 169
Show Information Displays STA values used for the bridge 174
Configure Interface
Configure Configures interface settings for STA 175
Show Information Displays interface settings for STA 180
MSTP Multiple Spanning Tree Algorithm 183
Configure Global 183
Add Configures initial VLAN and priority for an MST instance 183
Modify Configures the priority or an MST instance 183
Show Configures global settings for an MST instance 183
Add Member Adds VLAN members for an MST instance 183
Show Member Adds or deletes VLAN members for an MST instance 183
Show Information Displays MSTP values used for the bridge
Configure Interface 187
Configure Configures interface settings for an MST instance 187
Show Information Displays interface settings for an MST instance 187
Traffic
Rate Limit Sets the input and output rate limits for a port 189
Storm Control Sets the broadcast storm threshold for each interface 190
Priority
Default Priority Sets the default priority for each port or trunk 193
Queue Sets queue mode for the switch; sets the service weight for each queue
that will use a weighted or hybrid mode
194
Trust Mode Selects DSCP or CoS priority processing 198
Table 4: Switch Main Menu (Continued)
Menu Description Page