LevelOne GEP-1070 - Page 25

25
Menu
Description
Page
Communities
Configures community strings
64
Users
Configures SNMP v3 users on this switch
65
Groups
Configures SNMP v3 groups
66
Views
Configures SNMP v3 views
68
Access
Assigns security model, security level, and read / write
views to SNMP groups
69
Network
76
Limit Control
Configures port security limit controls, including secure
address aging; and per port security, including
maximum allowed MAC addresses, and response for
security breach
76
NAS
Configures global and port settings for IEEE 802.1X
78
ACL
Access Control Lists
89
Ports
Assigns ACL, rate limiter, and other parameters to
ports
89
Rate Limiters
Configures rate limit policies
91
Access
Control List
Configures ACLs based on frame type, destination
MAC type, VLAN ID, VLAN priority tag; and the action
to take for matching packets
92
DHCP
Dynamic Host Configuration Protocol
98
Snooping
Enables DHCP snooping globally; and sets the trust
mode for each port
98
Relay
Configures DHCP relay information status and policy
100
IP Source Guard
Filters IP traffic based on static entries in the IP
Source Guard table, or dynamic entries in the DHCP
Snooping table
102
Configuration
Enables IP source guard and sets the maximum
number of clients that can learned dynamically
102
Static Table
Adds a static addresses to the source-guard binding
table
104
ARP Inspection
Address Resolution Protocol Inspection
105
Configuration
Enables inspection globally, and per port
105