71
PARAMETERS
These parameters are displayed:
◆ Group Name – The name of the SNMP group. (Range: 1-32 characters, ASCII characters
33-126 only)
◆ Security Model – The user security model. (Options: any, v1, v2c, or the User-based
Security Model – usm; Default: any)
◆ Security Level – The security level assigned to the group:
■ NoAuth, NoPriv – There is no authentication or encryption used in SNMP
communications. (This is the default for SNMPv3.)
■ Auth, NoPriv – SNMP communications use authentication, but the data is not
encrypted.
■ Auth, Priv – SNMP communications use both authentication and encryption.
◆ Read View Name – The configured view for read access. (Range: 1-32 characters, ASCII
characters 33-126 only)
◆ Write View Name – The configured view for write access. (Range: 1-32 characters, ASCII
characters 33-126 only)
WEB INTERFACE
To configure SNMPv3 group access rights:
1. Click Configuration, Security, Switch, SNMP, Access.
2. Click Add New Access to create a new entry.
3. Specify the group name, security settings, read view, and write view.
4. Click Save.
To Next Page
Loading...
