91
WEB INTERFACE
To configure 802.1X Port Security:
1. Click Configuration, Security, Network, NAS.
2. Modify the required attributes.
3. Click Save.
Access Control List (ACL)
An Access Control List (ACL) is a sequential list of permit or deny conditions that apply to IP
addresses, MAC addresses, or other more specific criteria. This switch tests ingress packets
against the conditions in an ACL one by one. A packet will be accepted as soon as it
matches a permit rule, or dropped as soon as it matches a deny rule. If no rules match, the
frame is accepted. Other actions can also be invoked when a matching packet is found,
including rate limiting, copying matching packets to another port or to the system log, or
shutting down a port.
Assigning ACL Polocies and Responses
Use the ACL Port Configuration page to define a port to which matching frames are copied,
enable logging, or shut down a port when a matching frame is seen. Note that rate limiting
(configured with the Rate Limiter menu, page 91) is implemented regardless of whether or
not a matching packet is seen.
PATH
Configuration \ Security \ Network \ ACL \ Ports
Figure 32: ACL Port Configuration
To Next Page
Loading...
