Publication date: June, 2015
Revision A1
2-21 SMTP Configuration
The function is used to set an Alarm trap when the switch alarm then you could set the SMTP
server to send you the alarm mail.
Web Interface
To configure the SMTP Configuration in the web interface:
1. Click Configuration, SMTP Configuration
2. Scroll to select the Severity Level
3. Specify the parameters in each blank field.
4. Click the Apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 3-21.1: The SMTP Configuration
Parameter description:
These parameters are displayed on the SMTP Configuration page:
Mail Server :
The IP address or hostname of the mail server. IP address is expressed in dotted decimal
notation. This will be the device that sends out the mail for you
User name :
Specify the username on the mail server.
Password :
Specify the password on the mail server.
To Next Page
